Dell Precision Tower 7910 Owner's Manual page 57

Option
Date/Time
Table 3. System Configuration
Option
Integrated NIC
Integrated NIC 2
Serial Port
SATA Operation
Tower 7910
Drives
Description
Allows you to configure the integrated network controller. The
options are:
• Enable UEFI Network Stack
• Disabled
NOTE: You can use the Disabled option, only if Active
Management Technology (AMT) option is disabled.
• Enabled
• Enabled w/PXE (Default)
Allows you to configure the
integrated network controller. The
options are:
• Enabled (Default)
• Enabled w/PXE
NOTE: This feature is supported
only on Tower 7910.
Identifies and defines the serial port settings. You can set the
serial port to:
• Disabled
• COM1 (Default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even if
the setting is disabled.
Allows you to configure the internal SATA hard-drive controller.
The options are:
• Disabled
• ATA
• AHCI (Default)
NOTE: SATA is configured to support RAID mode. No SATA
operation support in Tower 7910.
Description
• Enable Legacy Option ROMs
(Default)
Allows you to set the date and time. The
changes to the system date and time
takes effect immediately.
57