Janome 900CPX Instruction Manual page 18

Janome 900CPX Instruction Manual
3 4
e
y
5
6 7
i
8 9
www.aaasewing.com
r
t
u
!0
o
3 Hold the thread at both ends and tug gently to
ensure the thread is correctly inserted between
the tension disks. ( If the presser foot lifter is
raised, the thread easily inserts between the
tension disks.)
e Tension dial
r Tension disks
4 Pass the thread through the looper thread guide (A)
from the right.
t Looper thread guide (A)
5 Pass the thread through the eyes of the looper
take-up levers.
y Looper take-up lever
NOTE:
Be sure to raise the needles to the highest position so
the eyes of the looper take-up levers will align.
6 Slip the thread behind the looper thread guide (B)
from the right.
u Looper thread guide (B)
7 Pull the looper release knob and the looper will slant
to the right for easy access.
i Looper release knob
8 Pass the thread through the eye of the looper thread
guide (D) then through the eye of looper.
Draw the thread end 4" (10 cm) to the back.
o Looper thread guide (D)
!0 Eye of the looper
NOTE:
You may use a pair of tweezers.
9 Push the looper in the direction of the arrow, back to
the original position.
14
900cpx Owners Manual/ User Guide