General Voltage Checking - Nokia 3600 Slide Service Manual

RM-352; RM-354
RF troubleshooting
Phoenix preparations
Install the phone specific data package, for example
specific settings..
Auto tuning procedure
1 Make sure the phone (in the jig) is connected to the equipment. Else, some menus will not be shown in
Phoenix.
2 To go to autotune, select
3 Start autotuning, clicking the

General voltage checking

Steps
1. Set up the main board in the module jig. The phone should be in local mode.
2. Check the following:
#
1 Vbat at N1002 (FEM)
2 Vbat at N1001 (Transceiver)
3 VCCXO supply
Issue 1
Tuning (Alt-U) > Auto-Tune (Alt-A) from the menu. Set up the cable loss correctly!
Tune button.
Signal name
COMPANY CONFIDENTIAL
Copyright © 2008 Nokia. All rights reserved.
RM-352_DP20_1.00_04.09.1.exe . This defines phone
Test point
J2903 3.0-4.7 V
C1002 3.0-4.7 V
C2213 2.4-2.6 V
Voltage (all bands)
Page 4 –7