Dish Network 196812 User Manual page 69

Combination Devices
If you are programming the remote to operate a combination device, such as a TV/VCR or
a TV/DVD, program the remote control in one mode, and then repeat the procedure in the
other mode. For example, to program the remote to control a TV/VCR using code 748,
follow the instructions to program the remote to control the TV using code 748, and then
repeat the instructions for the VCR using the same code.
Programming Using Device Code Tables
Program the remote to control other devices using device codes.
2
1
DVD
DVD
Turn
Find code
device on
in tables
Turn the device on, using the device's front panel buttons or its remote control.
1
Using the insert of device names and codes that came with the remote control, find the
2
brand name of the device. If the brand is not listed, see Programing using Device Codes
Scan.
Press and hold the Mode button until all the other mode buttons light up, and then release
3
the button. The Mode button flashes. For example, hold TV for a TV until all of the other
mode buttons light. When you release it, TV flashes.
For AUX only. Press 0 for a second TV, 1 for a second DVD and/or VCR, 2 for a tuner or
4
amplifier, or audio receiver. If you are not programming in AUX mode, skip to step 5.
Enter one of the three-digit device codes for your brand from the table using the number
5
buttons. The three-digit device code should be for the brand name of your device that
you found in step 2.
If you want to program Limited Mode, press 1. If not, skep to step 7. See Limited Mode
6
for more information.
Press POUND (#). The Mode button flashes three times.
7
Press POWER to turn off the device. If the device does not turn off, go to step 10. If the
8
code works, the device turns off.
3-4
5-6
7
Press & hold
Mode button
Press
until all Mode Enter
POUND
code
buttons light up
from table
Receiver Customization
Operating Other Devices
9-11
8
DVD
Test to make
sure code
Press
works
POWER
to see if device
turns off
59