Volume Adjustment; Audible Beep Confirmation; Using The Tft Monitor; Resetting The System - Jensen VX3010 Operating Instructions Manual

VX3010
Mute
Press the volume knob on the front panel or press the [MUTE] Button on the
remote control to mute the volume from the unit.

Volume Adjustment

Volume Increase/Decrease
To increase or decrease the volume level, turn the rotary encoder on the front
panel. When the volume level reaches "0" or "50", a beep sounds, indicating that
the adjustment limit has been reached. The TFT screen displays the volume level
for 3 seconds.

Audible Beep Confirmation

An audible beep tone confirms each function selection. The beep tone can be
disabled through the Setup menu.

Using the TFT Monitor

Open / Close monitor
Press the [OPEN] Button on the front panel or remote control to open or close the
display panel. NOTE: Never manualy open or close the display panel.
Change the monitor tilt angle
Due to the inherent character of LCD, you will get different vision impressions
when you watch it from different angles. The display angle of this unit can be
changed; hence you can select the best angle where you can get the best vision
impression. Press and hold the [OPEN] Button to enter display angle setting mode,
and rotate the knob to adjust. NOTE: Never manually tilt the display panel.

Resetting the System

Soft Reset - To correct a system halt or other illegal operation, use the tip of a pen to
press and release the reset button located just below the front panel control knob.
[RESET] Button
Figure 5. System Reset Button
For a Hard Reset- Touch the System Reset Icon on the Third Settings Screen.
After a system reset,the unit restores all factory default settings.
NOTE: If the unit is reset while a DVD is playing, the unit will return to Main Menu
once the reset is complete.
16
128-9270 VX3010 Operating Instructions 02 20 2014.indd 16 2/20/2014 5:54:50 PM