Table of Contents
Advertisement
CLEANING THE COOKING GRIDS
After cooking, turn control knobs to "OFF" and let
grill cool before attempting to clean your cooking
grids.
Before first use and periodically it is suggested that
you wash the cooking grids in a mind soap and
warm water solution. You can use a washcloth, a
vegetable brush or a steel wool to clean your
cooking grids if you desire.
CLEANING THE FLAME TAMER
Washing the flame tamer after every use is not
necessary but periodically it is suggested you wash
the tamer in a soap and warm water solution. Use a
wire brush to remove stubborn burnt on cooking
residue. Dry the flame tamer thoroughly before you
re-install into the grill housing.
CLEANING THE BURNER TUBES AND BURNER
PORTS (TO PREVENT FLASH-BACK) SPIDER
AND INSECT WARNING!!!
Spiders and insects can nest in the burners of this or
any other grill, and cause the gas to flow from the
front of the burner. This is a very dangerous
condition, which can cause a fire to occur behind the
valve panel (flash back), thereby damaging the grill
and making it unsafe to operate. We recommend
that you inspect for spiders regularly in late summer
or early fall when they are most active.
To inspect for spiders:
1.Turn the burner valve off.
2.Turn the gas supply off fully (Turn clockwise to
stop).
3.Remove cooking grids, flame tamers.
4.Unscrew and remove the burners from the grill
housing.
5.Carefully lift each burner up and away from gas
valve orifice. Inspect for any obstructions ands use
air pressure or a clean plastic brush to clear the
burner tube or any debris.
6.Carefully replace the burner in its exact position
directly in front of gas valve orifice.
CLEANING & MAINTENANCE
BURNER CLEANING
1. Wire brush entire surface of burner to remove
food residue and dirt.
2. Clean any clogged ports with a stiff wire such as an
open paper clip.
3. Inspect the burner for damage (cracks or holes) and if
such damage is found, order and install a new burner.
After installation check to insure the gas valve orifices are
correctly placed inside the ends of burner tubes. Also
check the position of the spark electrode.
CLEANING THE GREASE TRAY
The grease tray should be emptied and wiped done
periodically and washed in a mild detergent and warm
water solution. A small amount of sand or cat litter may be
placed in bottom of grease try to absorb the grease
ANNUAL CLEANING OF GRILL HOUSING
Burning-off the grill after every cook out will keep it ready
for instant use; however once a year minimum you should
give the entire grill a thorough cleaning to keep it in tip
operating condition
INTERIOR:
1.
2. For NG turn the safety valve to off
3. Remove and clean the cooking grids, flame tamers.
4. Brush the inside and bottom of the grill with a stiff wire
brush, and wash down with a mild soap and warm water
solution. Rinse thoroughly and let dry.
5. Check spark electrode, adjusting as instructed.
Electrode tip pointing toward the tip of gas collector and
approximately 3/16" from the tip of collector tube
6. Replace flame tamers cooking grids.
7. Reconnect to the gas source and observe the burner
flame for correct operation.
IMPORTANT:
You should NOT line the bottom of the grill housing with
aluminum foil, sand or any other grease-absorbent
substance. Grease will not be able to drip down into
grease collector and a grease fire could occur.
Your gas grill is made of heavy stainless steel; it should
provide you with years of trouble-free service
Turn the burner valve off.
.
16
J23Y06N-1
Advertisement
Table of Contents
Troubleshooting
