Follow Instructions - All operating and user or against them, paying particular attention to instructions should be followed. Russound Collage System Installation Manual...
Page 3
National Electrical Code, Section 810, manufacturer for proper installation instructions. ANSI/NFPA No. 70-1984. Antenna lead in wire Grounding conductors Electric service equipment Ground clamps Power service grounding electrode system Russound Collage System Installation Manual...
Media Manager (CMM1) Collage is a Powerline Carrier (PLC) based whole-house audio system The Media Manager is the bridge between the Collage system keypads, for retrofit applications. Its two components are the CAK1 amplified the internal home network (LAN) and the outside world (WAN). Its keypad and the CMM1 media manager.
Expanded view of back box assembly separator plate to the back of the keypad. Note: Speaker wire and an optional RG6 coax antenna should be run to the back box location before the back box is installed. Russound Collage System Installation Manual...
CMM1 Media Manager Bind - recessed button to (back) be pressed during binding process Power input - for connecting Ethernet ports - RJ45 CAT-5 connection for AC power cord network connection Russound Collage System Installation Manual...
CAT-5 straight through cable (T568A standard). The network must be a minimum 10/100 BASE-T Ethernet. CAK1 keypad CMM1 NAS server (installed) CAT-5 cable INTERNET Computer RJ45 T568A wiring standard Required DHCP router with NAT/firewall Cable or DSL Modem Russound Collage System Installation Manual...
If testing from a light switch, attach an adapter with clips on flying leads (see diagram to right) to test off the feed supplying the light switch. Three-prong plug (binding, outlet test) Keypad assembly with pigtail Russound Collage System Installation Manual...
From the Initial Setup screen, choose Name, then use the wheel to scroll through the alphabet (upper and lower case), and press Select to enter each letter. When finished, press Enter to save. Complete the naming procedure for all keypads. Russound Collage System Installation Manual...
Power up units Each device shows a network strength number that must be greater to qualify as a Collage keypad installation site. If the number Power on each keypad with appropriate pigtail at its intended for a device is 6, efforts should be made to maximize that number. If location.
This can devices. The beauty of Collage is that all Gridcast network information save time and retesting if only a single unit must be relocated. In the can be seen from any one keypad, simply by choosing to see Details.
These can be used as reference points with the template to assist in centering the keypad. The diagram at right depicts the template. Single-gang Guide Double-gang Guides Corner marks for cut-out Collage Keypad Installation template Russound Collage System Installation Manual...
The CAK1 supports an optional external 75-ohm coaxial antenna (up to RG6). Run the coaxial cable to the back box location. Thread the cable through the top of the back box and pull through. Optional inverted back box installation Russound Collage System Installation Manual...
Replace the pin in the grommet to secure the power pocket to the back box. Connections and assembly of keypad parts Russound Collage System Installation Manual...
Power supply plug (from power supply) Speaker cable with • FM antenna cable snap connector All cable connections are made to the keypad before it is secured in the back box. Monopole antenna Power supply connection Monopole antenna with F-connector Russound Collage System Installation Manual...
Snap the bezel in place on the keypad starting at the bottom of the keypad and snap it into place at the top. CAK1 keypad (back panel) Russound Collage System Installation Manual...
Required firmware update Note: A broadband internet connection is required to perform an update. The Collage system ships with initial setup software only. A firmware update must be performed to load the most current firmware version for full functionality. To update firmware, select Update. The Status screen shows when an update is running and its progress (percent finished).
Press to save edits and exit (slow) or press and hold (fast) to turn naming screens room volume up or down. From Volume screen, click wheel IR receiver - Receives IR commands can be used from remote control Russound Collage System Installation Manual...
If any selections are made on the keypad away from this screen, room monitor automatically shuts off. This prevents "secret" monitoring. Russound Collage System Installation Manual...
The Collage music system allows you to search through and play music files (MP3, WMA, etc.) stored on a networked PC. In order for music files to be accessed by Collage over the network, the computer on which the files reside must be enabled for media sharing.
HomePlug 1.0 Extended @ 28Mbps Power requirements: 100~240 VAC 50/60 Hz 0.7A max Security: 56-bit DES encryption Operating temperature range: 32-86º F (0-30º C) max Powerline data transfer rate: 14/28 Mbps (indoor use only) Frequency band: 4.3-20.9 MHz/2.1-26.8 MHz Russound Collage System Installation Manual...
If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owner’s Before returning a unit for repair, call Russound at (603) 659-5170 for a expense and with prior written permission. Accidental damage and Return Authorization number.
Page 25
NOTES Russound Collage System Installation Manual...
Page 26
NOTES Russound Collage System Installation Manual...
Page 27
NOTES Russound Collage System Installation Manual...