Convection Fan / Capacitor; Cooling Fan; Broil Element; Bake Element - Jenn-Air PRD3030 series Service Manual

Disassembly Procedures
!

Convection Fan / Capacitor

1. Disconnect power supply to unit.
2. Remove oven door, see "Oven Door" procedure.
3. Remove bake element, see "Bake Element"
procedure.
4. Remove screws securing convection baffle to rear of
oven cavity.
5. Remove screws securing convection fan to rear of oven
cavity.
NOTE: When removing the last two screws, hold fan
assembly in place.
6. Gently lower fan and place on the oven bottom.
7. Disconnect and label wire terminals on fan.
NOTE: When reinstalling, install screws into center
holes on convection fan to assist in aligning
corner holes.
8. Replacement of capacitor can be done two ways.
• Removal of convection fan.
• Accessing through the rear of the unit and removing
the rear motor housing.
9. Reverse procedure to reassemble.

Cooling Fan

1. Disconnect power and shut off gas supply to unit.
2. Remove maintop, see "Maintop" procedure.
3. Remove screws securing cooling fan to unit chassis.
4. Disconnect and label wire terminals from cooling fan.
5. Reverse procedure to reassemble.

Broil Element

1. Disconnect power supply to unit.
2. Remove oven door, see "Oven Door Removal"
procedure.
3. Remove screws securing broiler element to rear of
oven cavity.
4. Remove screws securing broiler element bracket to
oven cavity ceiling.
5. Gently pull element out far enough to disconnect wire
terminals.
NOTE: When attaching wire connection, verify
connections are tight.
NOTE: When handling element, be sure not to bend the
element.
6. Reverse procedure to reassemble.
©2004 Maytag Services
WARNING
16022880 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

Bake Element

1. Disconnect power supply to unit.
2. Open oven door and remove all oven racks and rack
supports from oven cavity.
3. Remove screws securing element to oven cavity
located at the rear of the cavity.
4. Gently pull element out far enough to disconnect wire
terminals.
NOTE: When attaching wire connection, verify
connections are tight.
NOTE: When handling element, be sure not to bend the
element.
5. Reverse procedure to reassemble.

Gas Train

1. Disconnect power and shut off gas supply to unit.
2. Remove maintop, see "Maintop" procedure.
3. Remove screws securing kick plate at each top
corner.
4. Remove screws securing regulator and gas train
brackets in place.
5. Disconnect gas line from regulator.
6. Disconnect gas line at top of unit going to manifold.
7. Remove gas train from unit.
8. Reverse procedure to reassemble.

Door Latch

1. Disconnect power supply to unit.
2. Remove screws securing latch cover.
3. Remove screws on far sides of latch plate.
4. Slide latch assembly out of unit chassis
5. Disconnect and label wire terminals on latch
assembly.
6. Reverse procedure to reassemble.

Oven Door

1. Open oven door to the fully opened position.
2. Secure hinge lock by sliding copper clip on lower
hinge over the finger located on the underside of the
top hinge.
3. While holding the oven door securely, start to close
the door and gently lift upward and outward to
disengage hinges from receptacles.
Reinstalling Oven Door
• After oven door is placed on hinge receptacles, the
door will make a clicking noise when closed for the
first time, indicating the oven door is properly aligned.
NOTE: In the event that the oven door is off of the oven
and hinges are not closed together, the hinges
will need to be compressed and copper clip
needs to be closed.
19