Pentair IntelliBrite Installation And User Manual page 11

4. Using a ¼" nut driver and a #3 Phillips screwdriver, remove the nut uni-tension wire clamp. Place the nut aside
for reinstallation.
5. Remove the face ring and wire clamp from the light housing.
6. With the light resting on its base, carefully pry off the gasket to remove the lens. Discard the gasket. A NEW
LENS GASKET (P/N 79101600) MUST BE USED EACH TIME THE LIGHT IS REASSEMBLED. See page 10
for replacement kit part numbers.
Light housing
Gasket and lens
7. Using a ¼" nut driver, carefully remove the four retainer nuts from the LED light assembly. Place the nuts
aside for reinstallation.
8. Unplug the LED light assembly connector and remove the assembly from the housing.
Spring clamp: Remove nut and screw
Retaining nut
(4x)
Face ring
Unplug the LED
light assembly
connector to
remove the light
assembly from
its housing
7