Zipp - Kenmore 385.19110 Owner's Manual

Zipper Sewing
Machine setting
_i_ Pattern
_2_LED display
_3_Foot
01
E: Zipper foot
Attaching the zipper foot
To sew on the left side of the zipper, attach the foot
holder to the right pin on the zipper foot.
To sew on the right side of the zipper, attach the
foot holder to the left pin on the zipper foot.
_i_ Groove
_2_Pin
_3_ To sew left side
_4_ To sew right side
01
I
I
+
Fabric preparation
Add 3/8" (lcm)to the zipper si This is the
overall opening size.
_i_ Right side
_2_ Opening
_3_ Zipper
_4_ 3/8" (1
_5_End of
_6_ Slider
_7_ Zipper te
_8_ Zipper
Place right sides of fabri_ _ogether and sew a bottom
seam 3/4" (2 cm) from the fabric edge to the esti-
mated zipper bottom stop position.
Sew in reverse a few stitches to lock.
Increase the stitch length to 5.0, set the needle thread
tension to 0, and baste the entire length of the zipper
opening.
_9_Bottom seam
_ Zipper bottom stop position
_ Reverse stitch
_ Basting stitch
_i_ 3/4" (2 cm)
• Starting to sew
[iq Attach the zipper foot on the right-hand side of the
pin.
Fold back the upper layer seam allowance. Fold
back the lower layer seam allowance to form a 1/8"
(0.3 cm) margin of the fabric. Place the zipper teeth
next to margin edge and pin margin to the zipper
tape.
Return the stitch length and thread tension to the
original settings.
Lower the zipper foot so it aligns with the zipper
teeth.
Sew from the bottom stop to the entire length of the
zipper tape, removing pins as you go.
_i_ Upper layer _2_Lower layer
_3_1/8" (2 cm) margin _4_ Margin edge
_5_Bottom stop _6_ Zipper length
®