Table of Contents
Advertisement
section
Assembly Instructions
Please read these assembly instructions thoroughly before attempting to assemble the CA63 digital piano.
Please ensure that two or more people work on assembling the CA63 digital piano, especially when lifting
the main body of the instrument onto the stand in step 3.
Included parts
Before attempting to assemble the CA63 digital piano, ensure that all parts below are included.
A Phillips-head screwdriver (not included) will also be required in order to assemble the instrument.
a Main body x 1
c Pedal board x 1
Pedal support bolt x 1
1. Assembling the side panels b, pedal board, and pedal support bolt c
Unfasten and extend the pedal connection cable attached to
the bottom of the pedal board c.
Insert the pedal support bolt approximately 1 cm into the
pedal board, using the hole shown in the diagram.
Attach the pedal board c to the left and right side panels b
using the temporary mounting screws located on either end
of the pedal board. Ensure that the correct side panel is used
for the left and right side.
Ensure that the pedal board and side panels make close
contact, and that there are no large gaps between the
assembled parts.
Insert the four short silver tapping screws i into the holes as
shown, and securely fasten the pedal board to the and left and
right side panels.
Ensure that the left and right side panels are
securely fastened to the pedal board.
90
(CA63 only)
b Side panel x 2
(left, right)
j Washer x 2
d Back board x 1
i
Screws (flat tip)
e Screw (with flat washer and spring
washer) x 2
f Screw (long, black) x 2
g Screw (short, black) x 4
Screws (pointed tip)
h Tapping screw (long, black) x 4
i Tapping screw (short, silver) x 4
k Cable clamp x 2
m Headphone hook set x 1
Headphone hook x 1
Mounting screw x 2
b
Pedal cable
Temporary
mounting
Pedal support bolt hole
screw
l Power cable x 1
b
i
Advertisement
Table of Contents
