Advertisement
OTR (ONE TOUCH RECORDING)
Press the
button. The following display will appear:
You are now able to change the settings (default) for recording:
Select the parameters to be changed with the
Target: If more than one storage medium is connected to the receiver or if a storage medium with several par-
titions has been connected, you can select the storage medium or partition on which the recordings
are to be stored.
The external USB storage device connected to the receiver at the time the recording
was programmed must be connected to the receiver when recording starts. If the
USB storage device is switched between recording programming and recording start,
the receiver will not proceed with recording (see message text on page 14).
Start: Time of start (can also be entered with the keypad)
End:
End time (can also be entered with the keypad)
Once all settings have been made, use the
Press the
button to begin recording.
Note: During the recording process, only the programme being recorded may be
viewed!
6
RECORDING
buttons. Use the
buttons to access the last line "Recording ...".
Selected USB
storage device
Selected partition
buttons to make changes.
Advertisement
