Advertisement
MESSAGES/ERROR MESSAGES
This message is displayed whenever a hard disk which is not
FAT32 formatted is connected to a USB interface. The hard disk
can then be formatted in the menu "Service menu/USB Device
Management" (see pages 3-4). If the connected hard disk
contains FAT32 partitions, this message is not displayed.
USB device could not be registered. Please try again..
General error (inaccessible play position, invalid path...)
There is either no USB device installed or the wrong device
has been installed e.g. the USB device connected to the
receiver at the start of recording is not the one which was
connected during programming of the recording.
The receiver is executing a task in the background.
After the task has been completed, the message will disappear
and the receiver can be operated as usual.
If formatting of the USB storage device is confi rmed with the
OK button, all data saved on the device will be permanently
deleted.
If the storage device does not have enough free memory when
the recording procedure is started (through OTR - One Touch
Recording or EPG timer recording), this message is displayed.
Check your recording list and delete recordings if necessary.
15
Advertisement
