Numbering Extensions And C.o. Lines - Samsung OfficeServ 7400 Installation Manual

8.3 Numbering Extensions and C.O. Lines

Once the OfficeServ 7400 system is booted, the MP40/LP40 board verifies the boards
mounted on each slot and saves this information as the default configuration of the system.
According to the setting of the S2 switches(SW6, SW7 and SW8) of the MP40 board, the
OfficeServ SME system assigns 3 or 4 digits to C.O. lines, extensions, and extension groups.
Refer to '3.2 Mounting Control Boards' of this manual for details on setting the S2 switch.
C.O. line numbers from 701 or 7001 are sequentially assigned to the C.O. line board
mounted on Slot 1 of the basic cabinet, and following numbers are continuously assigned
to the next board of the next slot. This numbering process continues until the C.O. line
numbers are assigned to all C.O. lines. However, only the numbers from 701 to 799 are
assigned when using 3 digits. For example, if a 8TRK board is mounted on Slot 1 and a
8TRK board is mounted on Slot 2, 701 is assigned to the C1/S1/P1 port and 712 is assigned
to the C1/S2/P4 port.(The 12
cabinet.)
Extension numbers from 201 or 2001 are sequentially assigned to the extension board
mounted on Slot 1 of the basic cabinet, and following numbers are continuously assigned
to the next extension board of the next slot. This numbering process continues until the
extension numbers are assigned to all extensions. However, only the numbers from 201 to
349 are assigned when using 3 digits.
The last port of the first 8DLI or 16DLI board is assigned to the attendant group as default.
All C.O. lines ring this attendant extension unless the default value is changed. Thus, a
phone with an LCD panel should be connected to the last port of the first 8DLI board.
Numbers between 500-549 or 5001-5049 are assigned to an extension group.
The numbers of C.O. lines, extensions, or extension groups can be changed using the MMC
724 program.
© SAMSUNG Electronics Co., Ltd.
th
C.O. line is assigned to the 4
OfficeServ 7400 Installation Manual
th nd
port of the 2 slot of the 1
st
8-3