Samsung OfficeServ 7400 Installation Manual page 80

CHAPTER 8. Ошибка! Стиль не определен.
8.2 Starting the System
The procedure for starting the OfficeServ 7400 system is as follows:
1) Check if the boards and cables are properly mounted and connected to the OfficeServ
7400 cabinet.
2) Turn on the power of the OfficeServ 7400 basic cabinet, and turn on the power of the
expansion cabinet.
3) Check the LEDs of the MP40 and LP40 boards.
The RUN LED of the MP40 board lights green and the SM LED flashes when the
system normally starts the booting process.
Once the booting is complete, the RUN LED of the MP40 board flashes green, and
the SM LED stops flashing and remains lighted.
The RUN LED of the LP40 board flashes when the power supply and processor
status of the expansion rack is normal.
If the Smart Media is not detected
If the system cannot detect the smart media, the SM LED of the MCP board might
not light or flash. In such cases, turn off the power of the basic cabinet, replace
the smart media and turn the power on again.
4) Check if the LED statuses of other interface boards are normal.
5) If the LED status of a MP40, LP40, or interface board is abnormal, turn off the power of
the cabinet and turn the power on again.
Board LED Status & Shut-down
- Refer to the 'OfficeServ SME System Manual' for LED statuses of each board
- Shut-down is hardly required while operating the OfficeServ SME system.
However, when shutting down the system due to reasons such as moving the
system, turn off the power of the expansion cabinet, and turn off the power of
the basic cabinet
8-2
© SAMSUNG Electronics Co., Ltd.