English
EACH TIME BEFORE OPERATION
Check the cleaner and especially
–
the power cable for damage
Checked the rotary brushes for the
–
presence of foreign objects
Fit the rotary brush that is suitable
–
for the job
If necessary top up the cleaning
–
agent solution in the tank
Connect the plug to the power
–
cable
Hang the strain-reliever
–
Plug the cable into the power
–
socket
Check that there are no obstacles
–
in the area to be cleaned
See the Operation Chapter for the
*
description
OPERATION
WARNING!
The cleaner must always be in motion
during operation!
Do not work on one spot as this may
damage the floor covering!
Do not start an unfilled appliance on
delicate floors!
Prior to start-up, tilt unit, activate
cleaning agent supply and switch on
drive unit for brush rollers.
Working in a lateral direction
Pull the catch upwards and hold
Tip the pushing handle backwards
Pull the lower lever;
Rotary brush drive ON
*
BR VS 400 *USA
Move the cleaner to the LEFT and
–
RIGHT by turning the pushing
handle
At the same time go backwards
–
slowly
Press the top switch-stirrup as
–
required, the cleaning agent
solution is fed to the rotary brooms
Working in lanes
Press the pushing handle downwards
and turn to the LEFT or RIGHT
Pull the catch upwards and hold
Tip the pushing handle backwards
Pull the lower lever;
Rotary brush drive ON
*
Move the appliance slowly
–
backwards or forwards in long
sweeping movements
Press the top switch-stirrup as
–
required, the cleaning agent
solution is fed to the rotary brooms
8
Switching off the cleaner
Release both levers
Tip the pushing handle forwards;
–
The catch locks automatically
*
When necessary push the pushing
–
handles down and turn back to the
initial position
Note:
Do not leave the cleaner on the rotary
brushes