T 300 T-Racer High Pressure Washer Accessory Part No. 2.640–508.0 Overview ... 1 Precautions ... 1-2 Assembly Instructions ... 3 Operating Controls ... 4 Normal Operating Settings ... 5 Parts List ... 6 In USA Call: 1-800-537-4129 or visit our website: www.karcher-usa.com...
5-gallon container. • The water supply temperature must not exceed 104°F/40°C. • Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc. • Always prevent debris from being drawn into the unit by using a clean water source.
Step 5 Tighten Lock collar to assemble by twisting counter clockwise. Step 1 Determine the PSI of your pressure washer. 1200–1600 PSI , Select the gray nozzles. 1700–2300 PSI , Select the yellow nozzles. Step 3 Insert upper handle into the lower handle by twisting together.
OPERATION CONTROLS Spray Power Adjust height of propeller spray head. Clockwise for wood surfaces counter clockwise for stone, concrete and tile. Air Flow Control Adjust the hover effect of the T-Racer by pushing the Air Flow Control into one of the positions from 0 – 1. The lowest position is 0 and the highest position is 1.
NORMAL OPERATION SETTINGS Horizontal Wood and Decks Adjust height of the spray head clockwise. Open (0) the air flow vents. Vertical Wood, Siding and Facades Adjust height of the spray head clockwise. Close (1) the air flow vents. Do not use on windows. Horizontal Tile, Concrete and Stone Adjust height of the spray head counter clockwise.