HP High-Performance Secure Hard Disk Setup Manual page 13

◦
HP High-Performance Secure Hard Disk (J8018A).
This HP Secure Hard Disk (J8018A) includes pre-mounted disk rails that are typically required
for installation in the formatter door.
●
The latest version of the printer/MFP firmware.
If you are installing an HP Secure Hard Disk in an existing printer/MFP, verify that it contains the
latest firmware. For firmware upgrade instructions, see the setup or use guides provided with your
printer/MFP.
NOTE:
HP Secure Hard Disk.
After upgrading the firmware, and restarting the printer/MFP, you can verify the firmware is installed
correctly by using the following procedure:
◦
Start a supported Web browser and enter the IP address or host name of the printer/MFP.
◦
Select the Settings tab and then select Security.
◦ In the Hard Drive and Mass Storage Security Settings section, select Configure.
Because the current hard disk cannot be encrypted, you should see information similar to the
following displayed in the Hard Drive Status section:
Encryption Status: Not supported
The Hard Disk, Drive Status, and Encryption Status fields indicate that the firmware is
capable of supporting the HP Secure Hard Disk.
ENWW
If you must upgrade the printer/MFP firmware, do this now before you install the
Hard Disk: Internal (Not encryptable)
Serial Number: ABCDE1234567890abcde
Drive Status: Enabled
What you need for installation 7