Maxtor ATA Hard Drive Installation Manual page 18

Figure 12. Pause/Break Key
on a Keyboard
the system, so you may need to restart your computer to read the
message. To make it easier to read the function key message:
Press the Pause/Break key after the memory count to
a.
pause the system boot. The Pause/Break key is usually located
in the upper right corner of your keyboard (see
Figure 12). Pausing the boot will give you time to locate the
function key message.
Press the Enter key to resume system boot.
b.
Immediately after the function key message appears, press
3.
the indicated key to enter Setup. Within the BIOS Setup
utility, navigation is limited to keyboard commands. The active
function keys are usually Esc, Tab, Page Up, Page Down, Enter, +,
-, spacebar, number, and arrow keys. The BIOS Setup utility
usually has keyboard instructions located somewhere on the screen.
Upon entering Setup, highlight the auto-detect IDE/HDD
4.
hard drives option (if displayed) and press Enter. This will
allow the system to automatically detect the devices on your
primary and secondary ATA channels.
Some BIOS Setup utilities do not have an auto-detect option on the
first page. In this case, choose the Standard CMOS option to detect
the hard drive.
Installing the Hard Drive
2
16