Bosch KGF Series Instructions For Use Manual page 21

Fault
Freezer compartment
door was open
for a long time;
temperature is no
longer reached.
Display indicates "E..". Electronics have
Controls have reduced
luminosity.
Freezer compartment
temperature display
flashes. Fig. 2/5
Possible cause
The evaporator
(refrigeration
generator)
in the No Frost system
is covered in thick ice
and can no
longer be defrosted
fully automatically.
detected a fault.
When the appliance is
not used for some
time, the display on
the fascia switches
to energy saving
mode.
A fault caused
the freezer
compartment
to become too warm
in the past.
Remedial action
To defrost the evaporator, remove
the frozen food
with the compartments, insulate well
and store in a cool location.
Switch off the appliance and move
it away from the wall. Leave
the appliance door open.
After approx. 20 min.
the condensation begins to run
into the evaporation pan,
at the rear of the appliance. Fig. .
To prevent the evaporation pan
from overflowing in this case,
mop up the condensation
with a sponge.
The evaporator is defrosted when
the water stops running
into the evaporation pan. Clean
the interior. Switch the appliance
back on again.
Call customer service.
As soon as the appliance is again
used, e.g. the door is opened,
the display switches back to normal
illumination.
When the alarm button 6 is pressed,
the temperature display stops
flashing. Fig. 2/5
The temperature display indicates
for 5 seconds the warmest
temperature which was reached
in the freezer compartment.
en
21