Pontiac 2009 Montana SV6 Owner's Manual page 96

/
(Remote Vehicle Start): This button will be on the
RKE transmitter if you have remote start.
To start the engine using the remote start feature, do
the following:
1. Aim the RKE transmitter, equipped with the remote
vehicle start button, at the vehicle.
2. Press and release the transmitter's lock button,
then immediately press and hold the remote
vehicle start button until the vehicle's turn signal
lamps flash, or for at least two seconds, if the
vehicle's lights are not visible. The vehicle's doors
will be locked.
When the vehicle's engine starts, the parking lamps
will turn on and remain on while the engine is
running.
3. If it is the first remote start since the vehicle has
been driven, repeat these steps, while the engine is
still running, to extend the engine running time by
10 minutes. Remote start can be extended one time.
2-8
After a remote start, the engine will automatically shut
off after 10 minutes unless a time extension has
been done or the vehicle's key is inserted into the
ignition switch and turned to ON/RUN.
The maximum number of remote starts or remote start
attempts between ignition cycles with the key is two.
If the remote start procedure is used again before
the first 10 minute time frame has ended, the first
10 minutes will immediately expire and the second
10 minute time frame will start.
After your vehicle's engine has been started two times
using the remote start button, the vehicle's ignition
switch must be turned to ON/RUN and then back to
LOCK/OFF using the key before the remote start
procedure can be used again.