Quadra-Fire QFI30FB-C Owner's Manual page 36

H. Install the Log Assembly
Log Set Assembly: LOGS-QFI35FB
Models: QFI35FB, QFI35FB-C
2 2
SRV2223-701 SRV2223-701
5 5
SRV2223-704 SRV2223-704
6 6
SRV2223-705 SRV2223-705
PILOT BRACKET PILOT BRACKET
BURNER LEDGE BURNER LEDGE
GRATE BAR GRATE BAR
GRATE TINES GRATE TINES
Figure 2. Reference Points for Log Placement
CAUTION: Logs are fragile, handle with care.
Glass Rock (2201-853): Fill each light tray evenly with the glass rock.
WARNING! Risk of Explosion! DO NOT place glass rock on the burner surface. DO NOT place glass rock directly over
burner ports. Improperly placed glass rock interferes with proper burner operation.
FLAT SPOT FLAT SPOT
FOR LOG #7 FOR LOG #7
LOG #1 CONTACTS BURNER LOG #1 CONTACTS BURNER
LEDGE AT TWO POINTS LEDGE AT TWO POINTS
CENTER LOG CUT OUT CENTER LOG CUT OUT
OVER PILOT BRACKET OVER PILOT BRACKET
Figure 4. Place Log #1
Log #1 (SRV2223-703): Position Log #1 as shown in Figure 4. See Figure 2 for additional points of reference. Center the
log over the pilot bracket. The log should rest on the burner ledge as shown in Figure 4.
Log #2 (SRV2223-701): Position Log #2 as shown in Figure 5. See Figure 2 for additional points of reference. Place the
left end of the log on the rear log support. Slide the log back until it rest against the back of the log support. The left end of
the log should touch Log #1. Swing the right end of the log counterclockwise until it contacts the right refractory wall.
36
1 1
SRV2223-703 SRV2223-703
3 3
SRV2223-702 SRV2223-702
SRV2223-707 SRV2223-707
4 4
SRV2223-706 SRV2223-706
LOG SUPPORTS LOG SUPPORTS
LIGHT TRAYS LIGHT TRAYS
BURNER BURNER
LOG PINS LOG PINS
LEDGE LEDGE
1 1
Quadra-Fire • QFI30FB-C, QFI35FB-C • 2221-901 Rev. S • 2/15
7 7
Figure 1. Logs Installed
Figure 3. Install Glass Rock
LOG #2 TOUCHES LOG #2 TOUCHES
LOG #1 HERE LOG #1 HERE
1 1
Figure 5. Place Log #2
GLASS ROCK GLASS ROCK
LOG #2 CONTACTS LOG #2 CONTACTS
RIGHT FIREBOX WALL RIGHT FIREBOX WALL
FLAT SPOT FLAT SPOT
FOR LOG #6 FOR LOG #6
2 2