Preliminary Checks; Checking The Appliance; Installing The Appliance; Connecting The Appliance - DeLonghi ESAM6620 Instructions For Use Manual

pressed twice consecutively)
C8. CAPPUCCINO
CAPPUCCINO (or frothed milk if pressed
twice consecutively)
C9. LATTE button: delivers 1 LATTE (or hot
milk if pressed twice consecutively)
C10. Button to select coffee taste or use
pre-ground coffee. (OK button to confirm
changes to menu settings)
C11. Hot water button.
(SET button to change menu settings)
C12. Rinse button. (
menu settings).
C13. P button to access and escape the menu.

PRELIMINARY CHECKS

Checking the appliance

After removing the packaging, make sure the
product is complete and undamaged and that all
accessories are present.
Do not use the appliance if it is visibly damaged.
Contact De'Longhi Customer Services.

Installing the appliance

Important!
When you install the appliance, you should
respect the following safety warnings:
the appliance on the work top, leave a space
of at least 3 cm between the surfaces of the
appliance and the side and rear walls and at
least 15 cm above the coffee maker.
damage. Do not place the appliance near
taps or sinks.
water it contains freezes. Do not install the
appliance in a room where the temperature
could drop below freezing point.
it cannot be damaged by sharp edges or
contact with hot surfaces (e.g. electric hot
plates).

Connecting the appliance

Important!
Check that the mains power supply voltage
corresponds to the value indicated on the rating
button: delivers
button to change
plate on the bottom of the appliance.
1
Connect the appliance to an efficiently earthed
and correctly installed socket with a minimum
current rating of 10A only.
If the power socket does not match the plug on
the appliance, have the socket replaced with a
suitable type by a qualified professional.
Using the appliance for the first time
Please note:
appliance and it is therefore completely
normal for there to be traces of coffee in the
grinder. The machine is, however, guaranteed
to be new.
soon as possible following the instructions
page 19.
1. Plug the appliance into the mains socket
and place the main switch on the back of the
appliance in the I position (fig. 1).
You must first choose the language (the
languages scroll through at intervals of about 3
seconds).
2. When English appears, press and hold the
language has been saved, the message
Follow the instructions indicated by the
appliance:
the MAX line with fresh water then replace in
the appliance (fig. 3).
Check that the hot water spout is inserted on
the nozzle and place a container underneath
(fig. 4).
5. Press the OK
begins to deliver water.
6. The appliance ends the first start up
appliance goes off.
The coffee maker is now ready for normal use.
10