Steering Wheel Installation - American Sportworks LANDmaster Operator's Safety And Service Manual

assembly

Steering Wheel Installation

1) Turn vehicle steering so that the tires are pointed
straight forward . There should be a mark showing the
top of the steering hub . Line up holes in steering wheel
with mounting holes so that the center spoke is pointing
down .
2) Install ¼" x ¾" socket head bolts through the center
cap, then into the steering wheel and steering hub .
Tighten with ¼" nylock nuts .
Cargo Bed Installation
1) Locate and install rear frame stubs at the rear of frame .
The bed pivot tube on the stub should be at the top .
Insert 5/16" x 2" socket head bolt . Loosely install 5/16"
center lock nut (do not tighten until after cargo bed is
installed)
SECTION 3
2) Place the cargo bed on the vehicle and insert a 5/8" x
4" hex head bolt through each pivot bracket and frame
stub tube . The bolt heads should be facing the
center of the vehicle with the nuts facing the ouside.
3) Tighten both 5/16" frame stub bolts and nuts .
4) Install the 5/8" nylock nuts on the pivot bolts . Tighten the
pivots and then loosen ¼ turn .
5) Loosen the bed latch pin bolt on the frame just enough
for it to slide in the adjustment slot .
6) Close the bed and position the latch pin bolt so that it
is at the bottom of the latch slot to prevent rattles .
Tighten the latch pin .
Note: Rear frame stubs not applicable on the LM700
with Independent Rear Suspension (IRS).
15