Assembly Instructions - American Sportworks LANDmaster Operator's Safety And Service Manual

assembly
A S S E M B L Y I N S T R U C T I O N S
WARNING
!
Wear proper eye protection during the uncrating
and assembly process to avoid potential eye injuries.
WARNING
!
RISK OF SERIOUS INJURY OR DEATH
The Brush Bars and the Seat and Shoulder Belt
are critical parts of the Operator / Passenger safety
system on this unit. Do not attempt to operate the
unit until all components have been properly installed.
Your new Utility Vehicle should include
the following items to be assembled:
Qty Item
6 ¼" x ¾" Socket head bolts (steering cap)
6 ¼" – 20 Nylock nuts (steering cap)
4 ¼" x 1" hex head bolts (poly bed)
10 ¼" Nylock nuts
4 ¼" x ¾" Carriage bolts (steel bed)
4 ¼" Flat washers
6 5/16" x 2" socket head bolts
12 5/16" curved washers
12 5/16" nylock nuts
4 5/16" x 2" hex head bolts
2 5/16" x 2 ¼" Socket head bolts (LM)
2 5/16" Nylock nuts (LM)
2 5/8" x 4" Hex bolt
2 5/8" nylock nuts
1 Set of keys
1 Steering wheel (with cap)
1 Bumper
2 Rear fenders
2 Rear frame stubs
1 Seat back
1 Cage
1 Cargo Bed with tailgate
1 Seat Back Frame
1 Seat Bottom
SECTION 3
Cargo bed
1 Uncrating the vehicle
• Wear your Safety Glasses to prevent eye injury.
• Using the Hammer and Pry Bar, remove cross supports at each end
of the crate and discard.
• Carefully pry and remove crate top and sides then discard.
2 Remove crate sides and discard
• Using Box Cutters, cut and remove the hold down ties.
• Remove seat back and other loose items from underneath unit and set
aside
• Remove the unit from the crate base and discard base.
NOTE: Some models may require installing front tires prior to removing
from crate.
3 Unpacking the components
• Unpack all of the loose components from the unit and set aside.
• Remove protective plastic from each component and discard.
Step 2 Crate Top
Step 3 Sides
Step 1 End
Cross Supports
Brush guard
Other items are located
under the unit
Step 1 End
Cross Supports
Step 3 Sides
13