Toyota 2010 FJ CRUISER Warranty & Maintenance Manual page 45

Check installation of driver's floor mat
Inspect and adjust all fluid levels
Lubricate propeller shaft (4WD)
Re-torque propeller shaft bolt
Replace cabin air filter
Rotate tires
Visually inspect brake linings/drums and brake pads/discs
Note: If 0W-20 oil WAS NOT used at the last oil change, replace engine oil and oil filter.
Inspect the following:
__ Ball joints and dust covers
__ Brake lines and hoses
__ Drive shaft boots (4WD)
4
__ Engine coolant
__ Exhaust pipes and mountings
Additional Maintenance Items for Special Operating Conditions
Driving on dirt roads or dusty roads:
Inspect engine air filter
Replace engine oil and oil filter
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading:
Replace engine oil and oil filter
Replace front differential oil (4WD)
Replace rear differential oil
Tighten nuts and bolts on chassis and body
Repeated trips of less than five miles in temperatures below 32°F / 0°C:
Replace engine oil and oil filter
Extensive idling and/or low speed driving for a long distance such as police, taxi or
door-to-door delivery use:
Replace engine oil and oil filter
D S V
EALER ERVICE ERIFICATION
D :
ATE
M :
ILEAGE
1
Reset the oil replacement reminder light ("MAINT REQD") or the message "OIL MAINTENANCE REQUIRED" on the
multi-information display after engine oil replacement.
2
Perform these service items only if you drive primarily under the conditions indicated.
3
Includes operating on roads which road salt has been applied.
4
Refer to "Engine Coolant" in the "Explanation of Maintenance Items" section in the back of this guide for more
information.
45,000 miles or 54 months
1
1
1
1
:
Maintenance Log
__ Front differential oil (4WD)
__ Radiator and condenser
__ Rear differential oil
__ Steering gear box
__ Steering linkage and boots
2
Maintenance Log
1
43