Maintenance Log - Toyota 2010 FJ CRUISER Warranty & Maintenance Manual

Hide thumbs Also See for 2010 FJ CRUISER:
Table of Contents

Advertisement

Maintenance Log

5,000 miles or 6 months
Check installation of driver's floor mat
Clean cabin air filter
Inspect and adjust all fluid levels
Rotate tires
Visually inspect brake linings/drums and
brake pads/discs
Additional Maintenance Items for
Special Operating Conditions
Driving on dirt roads or dusty roads:
Inspect ball joints and dust covers
Inspect drive shaft boots (4WD)
Inspect engine air filter
Inspect steering linkage and boots
Lubricate propeller shaft (4WD)
Re-torque propeller shaft bolt
Replace engine oil and oil filter
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top
carrier, or heavy vehicle loading:
Lubricate propeller shaft (4WD)
Re-torque propeller shaft bolt
Replace engine oil and oil filter
Tighten nuts and bolts on chassis and body
Repeated trips of less than five miles in
temperatures below 32°F / 0°C:
Replace engine oil and oil filter
Extensive idling and/or low speed driving
for a long distance such as police, taxi or
door-to-door delivery use:
Replace engine oil and oil filter
D
S
V
EALER
ERVICE
ERIFICATION
D
:
ATE
M
:
ILEAGE
38
Maintenance Log
2
3
3
1
3
3
1
1
1
:
10,000 miles or 12 months
Check installation of driver's floor mat
Clean cabin air filter
Inspect and adjust all fluid levels
Replace engine oil and oil filter
Rotate tires
Visually inspect brake linings/drums and
brake pads/discs
Note: Driving in heavy traffic, on dirt
roads or in urban, dusty or desert areas
may shorten the life of the cabin air filter.
Replacement may be needed if you notice
reduced air flow from the air conditioner
and heater or if the windows fog easily
when you use the Fresh mode. Consult
your dealer if any of these conditions
occur.
Additional Maintenance Items for
Special Operating Conditions
Driving on dirt roads or dusty roads:
Inspect ball joints and dust covers
Drive shaft boots (4WD)
Inspect engine air filter
Inspect steering linkage and boots
Lubricate propeller shaft (4WD)
Re-torque propeller shaft bolt
Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top
carrier, or heavy vehicle loading:
Lubricate propeller shaft (4WD)
Re-torque propeller shaft bolt
Tighten nuts and bolts on chassis and body
D
S
V
EALER
ERVICE
ERIFICATION
D
:
ATE
M
:
ILEAGE
1
2
3
3
3
3
:

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents