Dvd Drive; Removing A Dvd Drive - HP 9000 rp4410 User's & Service Manual

DVD Drive

The DVD drive is located on the front of the server.
WARNING Ensure that the system is powered off and all power sources have been disconnected
from the server before removing or replacing a DVD drive.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
CAUTION Failure to properly complete the steps in this procedure results in erratic system behavior or
system failure. For assistance with this procedure contact your local HP Authorized Service
Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions can result in damage to the server.

Removing a DVD Drive

To remove a DVD drive, follow these steps:
Step 1. Remove the front bezel. (See "Removing the Front Bezel" on page 180.)
Step 2. Grasp the front of the DVD drive and squeeze the locking tab to release the drive.
Step 3. Pull the drive straight out to remove it from the chassis.
Chapter 6
Removing and Replacing Components

DVD Drive

263