Table of Contents
Advertisement
Display
CHANGE PB TAPE
Image format which is different from the one set in the PB
FORMAT*
TAPE item on the VIDEO FORMAT[2/2] menu screen is
being played back.
LOW VOLTAGE*
Battery is low.
TAPE NEAR END*
There are less than 3 minutes remaining on the tape
(flashes only when recording).
TAPE END*
Displayed when the tape ends.
CHANGE 1394
Recording or playback video format and the IEEE1394
SWITCH*
setting is different when connected to the IEEE1394 port.
SWITCH TO VTR
Tried to use the FF or REW button in camera mode.
MODE*
HEAD CLEANING
Displayed when the video head is dirty. (Head clogging was
REQUIRED
detected during an edit search in shooting mode as well as
during playback and displayed.)
CLEANING TAPE!
Displayed when a head cleaning tape is inserted.
COPY GUARD!*
Tried to play back a copyguarded tape.
FAN MOTOR HOUR
Over the prescribed fan motor usage time.
PUSH CASSETTE
The videocassette cover is not firmly shut.
COVER*
CHANGE THE SYS-
Displayed when you attempt to change FRAME RATE item
TEM*
in the VIDEO FORMAT menu screen.
1080I INHIBIT
When 1080I CAMERA is set to OFF, during IEEE1394
CHANGE 1080I CAM.
input of 1080I format under VTR mode.
MENU
720P INHIBIT
When 1080I CAMERA is set to ON, during IEEE1394 input
CHANGE 1080I CAM.
of 720P format under VTR mode.
MENU
1080I REC INVALED! When REC/VTR trigger button is pressed while 1080I
CAMERA in the VIDEO FORMAT[1/2] menu screen is set
to ON and DR-HD100 is not connected.
* When status indications are magnified, warnings are not displayed on the LCD monitor.
X See "Magnified Status Indications on the LCD Monitor" on page 29.
Status
Action
Check the setting for the PB TAPE item.
X See page 76.
Charge the battery pack or replace it.
To continue shooting, find a new tape or replace the tape.
Replace the tape.
Set the IEEE1394 switch correctly, turn the power off and
then on again.
Press the CAM/VTR button to set VTR mode.
Clean with a special head cleaning tape.
X See page 7.
The display disappears when the head cleaning tape is
removed.
Cannot play back a copyguarded tape.
Please contact your local dealer or JVC.
Lightly push the top center of the videocassette cover.
When the FRAME RATE item setting is changed, the frame
rate system for this device is changed. Check the frame
rate to use before changing the setting.
X See pages 53 and 74.
Set 1080I CAMERA on the VIDEO FORMAT menu screen
to ON.
Set 1080I CAMERA on the VIDEO FORMAT menu screen
to OFF.
• Connect DR-HD100.
• Set 1080I CAMERA on the VIDEO FORMAT menu screen
to OFF.
103
Hide quick links:
Advertisement
Table of Contents
