Philips VLX User Manual page 77

Step 6. At head assembly, as shown in
Front Lens Ring
Front Lens
Optics Ring Plate
a. Remove three screws securing front lens and lens ring. Set components aside.
b. Note zoom motor wiring and routing. Disconnect wiring from zoom motors.
c. At front lens, loosen and remove and remove three stand-offs. Remove lens and place
d. Remove three compression springs and optic ring plate. Set components aside.
Step 7. Reassemble luminaire for fixed beam applications as follows:
02.96 90.000 1 0
Figure A-7: Front Lens Removal
lens on a clean, lint free cloth as not to damage or scratch lens.
07 Au gu st 2009 (Pre limina ry)
T
ROUBLESHOOTING AND
Figure A-3, remove front lens assembly as follows:
6-32 x 1/4" PPB Screws (x3)
Zoom Slide Standoffs (x3)
Compression Springs (x3)
A
M
AINTENANCE
61