Philips VLX User Manual page 76

❋
VARI LITE® - VLX™ W
Step 5. Remove protective EMI shields from around optics assembly as shown in
follows:
WARNING: On one EMI shield, it is imperative to identify the ambient temperature sensor that
protrudes through the EMI protective shield (it is on the opposite side where the front cover safety
tether connects. When this shield is removed, great care has to employed not to damage the sensor.
a. At EMI shield (side where front cover safety tether connects), remove all screws
b. Remove shield and set aside.
c. At other EMI shield (side with ambient temperature sensor), remove all screws securing
d. Carefully work shield over ambient temperature sensor taking care not to snag or pull
Note:
Some components not shown for clarity.
Front Cover Latch
(one on each side of cover)
Front Head Cover
Safety Tether
4-40 x 1/4" PPZ
SEMS Screws (x3)*
EMI Protective Shield
(side with front cover
tether connects to head)
6-32 x 1/4" PPZ
SEMS Screw*
60
L U
ASH UMINAIRE SER
securing cover. Be sure to note locations of removed screws in relation to EMI shield.
cover. Be sure to note locations of removed screws in relation to EMI shield.
sensor. Once shield is clear of sensor, set shield aside.
Figure A-6: Front Head Cover and EMI Shields Removal
07 Au gu st 2009 (Pre limina ry)
' M
S ANUAL
Figure A-2
Front Head Cover
EMI Protective Shield
(side with ambient
temperature sensor)
* Per shield.
02 .9 690.00 01 0
as