Table of Contents
Advertisement
2 CONTROLS AND CONNECTORS
2-1 FRONT PANEL
2-3 Rear Panel
1
CAM SW
ALARM
OUT
IN
COM
ALARM
RESET
1
Power cable
Connect the power plug to an AC 220-240 V, 50/60 Hz
outlet.
2
[MIC IN] mic input connector
Connect a microphone with 3.6-mm dia. plug. When
signals are input from both the microphone connector
and the audio input connector, audio signals are mixed
and recorded.
3
[VIDEO IN] video input connector (BNC)
Receives composite video signals from a connected
camera or other video source.
4
[AUDIO IN] audio input connector (RCA)
Receives audio signals from a connected audio source.
5
[AUDIO OUT] audio output connector (RCA)
Outputs audio signals.
6
[VIDEO OUT] video output connector (BNC)
Outputs composite video signals. Input camera signals
(composite video signals) can still be output through this
connector even when no power is supplied to the unit
(Power-Off Video Throughput function).
7
[REMOTE] remote connector
Connect the optional RM-G30U remote control.
ALARM
SERIES/CLOCK
COM
REC OUT
WARNING
TAPE
/REC
END OUT
OUT
IN
OUT
8
2
3
MIC
VIDEO
IN
IN
CAM SW
ALARM
ALARM
COM
SERIES/CLOCK
OUT
IN
REC OUT
WARNING
COM
ALARM
TAPE
/REC
REMOTE
RESET
END OUT
OUT
IN
OUT
OUT
7
6
Connecting the wires to the terminals
1. Hold the button down
2. Release the button to
button
8
[SERIES/CLOCK OUT] series recording signal/clock
reset signal output terminal
Outputs the series recording signals or clock reset
signals.
Select the output signal with the <TERMINAL SEL 1>
menu switch.
• Series recording signal output
When the <TERMINAL SEL 1> menu switch is set to
"SERIES", the series recording signal is output.
• Connect to the other VCR series recording signal input
terminal. When the tape being recorded in this unit
ends, a signal is output from this terminal to the
connected VCR.
• Set the signal output timing with the menu switch
<REC REMAIN> in the 3H to L24H Record modes or
with the menu switch <COUNT END> in the 48H to
240H modes.
For details on settings, refer to the menu switch
descriptions on page 21.
• Clock reset signal output
When the <TERMINAL SEL 1> menu switch is set to
"C.ADJ", the clock reset signal is output when the
internal clock is at AM0:00 and PM0:00. When
connected to the [CLOCK IN] terminal of another
SR-9240E/EK, this unit's time can be synchronised
with the time on the other VCR if the time difference is
within ±30 seconds.
4
AUDIO
IN
OUT
5
8
and insert the wire
over the top of the
terminal.
lock the wire in the
terminal.
11
Advertisement
Table of Contents
