Table of Contents
Advertisement
Malfunction described in Chart 13 can be
caused by inappropriate tightness the screw.
If the gap between the panel and ceiling still
exists after fastening the screws, the height of
the indoor unit should be modified again. (Refer
to chart 14-left)
You can modify the height of the indoor unit
through the openings on the panel's four corners, if
the lift of the indoor unit and the drainpipe is not
influenced (refer to chart 14-right).
4) Hang the air-in grid to the panel, then connect
the lead terminator of the swing motor and that
of the control box with corresponding
terminators on the body respectively.
5) Relocate the air-in grid in the procedure of
reversed order.
6) Relocate the installation cover.
a. Fasten the rope of installation cover on the bolt
of the installation cover. (Refer to chart 15-left)
b. Press the installation cover into the panel
slightly. (Refer to chart 15-right)
Advertisement
Table of Contents
