Cardo Systems Scala Rider FM User Manual page 9

conversation is over, the headset automatically tunes back in to the
FM Radio.
Turning the FM Radio On
While no call is on the headset, press and hold the Radio Button on
your headset for three seconds to turn on the radio. The radio tunes
in to the last radio station you were listening to. With some phones
you should wait a few seconds after ending a call before turning on
the Radio.
Turning the FM Radio Off
While the radio is turned on, press and hold the Radio Button for
three seconds to turn the Radio off.
Switching Preset FM Radio Station
There are six pre-set Radio stations available on your SCALA RIDER
FM. While the Radio is on, tap the Radio Button to cycle between
saved stations.
Searching for a New FM Radio Station
While the Radio is on, press and hold the Volume Up or Volume
Down Button for three seconds or until you hear the next station on
your headset.
Pressing Volume Up will search upwards (higher frequency). Pressing
Volume Down will search downwards (lower frequency). Once a
station is found, searching stops and you can hear the station.
To save this station, refer to the following section.
To continue searching, press the Volume Up or Volume Down Button
again for three seconds.
You may still continue to listen to the current unsaved station.
Pressing the Radio Button in this case will switch to the next saved
station.
Saving an FM Radio Station
The FM Radio is equipped with a memory capacity of six stations.
• Select the station you wish to replace by tapping the Radio
Button until you find the station you want to replace.
• Search for a new station as described above.
• Tap the Radio Button within 20 seconds of finding the station to
save the current station.
If you don't save the station, the Radio will exit search mode without
saving the current station. You can still continue to listen to the
current unsaved station. Tapping the Radio Button in this case will
move to the next saved station.
USING THE MP3 PLAYER WITH YOUR
HEADSET
Your SCALA RIDER headset can be connected to an MP3
player/audio device by simply plugging it to the Helmet
Clamp's jack with the audio cable as follows:
1. Power on the headset to have it on
Standby mode, flashing slowly in
Blue.
2. Connect one side of the audio cable
to your MP3 player/audio device's
jack and the other side to the helmet
Clamp's jack as shown in the photo.
3. Operate the MP3 Player/audio device
by using its buttons (FF/REW/PLAY /
PAUSE ).
9
SCALA RIDER FM™ |
®
Connect the audio cable to
the helmet Clamp's jack