Recording; Recording Features; Basic Recording - JVC HR-V510E Instructions Manual

Recording

Accidental erasure prevention
To prevent accidental recording on a
recorded cassette, remove its record
safety tab. To record on it later, cover
the hole with adhesive tape.

Basic Recording

Turn on the TV and select the video channel or AV mode.
A
Load a cassette
Make sure the record safety tab is intact. If not, cover the hole with
adhesive tape before inserting the cassette.
The recorder turns on, and the counter is reset, automatically.
B
Select recording channel
Press PR r/t or the number keys on the remote control or PR +/–
on the recorder.
You can select channel in the stop mode or recording pause mode.
C
Set tape speed
Press p(SP/LP). The current setting for the tape speed appears
on the display panel and the screen for about 5 seconds. Press
p(SP/LP) again to change the setting while tape speed is
displayed.
D
Start recording
On the recorder, press 7. Or on the remote control, while holding
7, press 4.
NOTE:
If the tape reaches its end during recording, the recording stops
and " " and " $" on the display panel blink. Press 0 on the
recorder to eject the cassette or press 3 to rewind the tape.
During recording
Pause recording
Press 9.
Press 4 to resume recording.
You can select channel in the recording pause mode.
Stop recording
Press 8 on the remote
control.
Record safety tab
OR Press 0 on the recorder.

Recording Features

Recording Resume Function
If there is a power outage during recording (or Instant Timer
Recording, or timer recording), the recording will resume
automatically when the power is restored to the recorder. (No
setting is required for this function.)
NOTE:
If a power outage exceed the recorder's memory backup time,
Recording Resume Function does not work.
Tape Remaining Time/Time Counter
Press – –:– – to display the tape remaining time and time counter
on the screen. To reset the time counter, press 0000.
NOTES:
Set "O.S.D." to "ON" to display the indications on the screen.
( 12)
Depending on the type of tape used, the tape remaining time
may not appear right away, or is not correct. "– –:– –" may
sometimes appear, or the display may blink on occasion.
Watching one programme while recording another
If your recorder is connected to the TV via the AV connection
( 4), press TV/VCR. The recorder's VCR indicator and the TV
broadcast being recorded disappear. Once recording is in
progress, all you need to do is to set the channel controls on the
TV for the station you wish to view.
The programme selected with the TV's channel controls appears
on the screen, while the one selected with the PR r/t on the
remote control or PR +/– on the recorder is recorded on the
tape.
Specifying recording length
— Instant Timer Recording (ITR)
During recording, press 7 on the recorder repeatedly until the
desired recording length appears on the display panel. "
display panel starts blinking.
Each time you press the button, recording length increases in
30-minute intervals (up to 6 hours).
The recorder turns off after recording is finished.
To cancel an ITR, press 8 on the remote control or 0 on the
recorder.
— 8 —
" on the