Kenwood TK-7100 Service Manual page 8

TK-7100
■ Flow Chart
Self programming mode
[MON]
[MON]
Channel setting mode
[SCN]
[MON]
RX frequency
[SCN] or [ ]
[MON]
RX signalling
[SCN] or [ ]
[MON]
TX frequency
[SCN] or [ ]
[MON]
TX signalling
[SCN] or [ ]
[MON]
Option signalling
[SCN] or [ ]
[MON]
SP unmute
[SCN] or [ ]
[MON]
Busy channel lockout
[SCN] or [ ]
[MON]
Beat shift
[SCN] or [ ]
[MON]
RF power
[SCN] or [ ]
[MON]
Wide/Narrow
[SCN] or [ ]
[MON]
Scan Del/Add
[SCN] or [ ]
[MON]
Priority channel
[SCN] or [ ]
[MON]
PTT ID
[SCN] or [ ]
[MON]
Scrmbler
[SCN] or [ ]
[MON]
Scrmbler code
[SCN] or [ ]
Return to channel setting mode
8
REALIGNMENT
[ ]
Channel Group
selection selection
[ ]
Change
frequency step
Hold [ ]
Blank
[ ]
Off
[ ]
QT
*
[ ]
QT
[ ] Hold
[ ]
DQT N DQT I
*
*
[ ] Hold
[ ]
DQT N DQT I
[ ]
[ ]
Change
frequency step
Hold [ ]
Blank
[ ]
Off
[ ]
QT
*
[ ]
QT
[ ]
Hold
[ ]
DQT N DQT I
*
*
[ ] Hold
[ ]
DQT N DQT I
[ ]
Not used when scan
priority is not fixed.
5-4. DTMF Setting Mode
Each radio can be setup in its action mode by using the
panel keys.
• Pressing [SCN] when " SELF " is displayed, sets the
DTMF setting mode.
• The data displayed using [SCN] is stored in the memory.
• Pressing [ ] to without storing it in the memory.
• Press [ ] to default status.
■ Flow Chart
Self mode (Display " SELF ")
[SCN]
[ ]
DTMF setting mode
The setup items for DTMF setting mode are listed below.
No. Function Choices
1 ID code 000~
9999999999
(Code squelch)
1 2 3 4 5 6 7 8
– – – – – 9 8 7
– – – – – 0 0 0
0000~9999
(Selective call)
(*1)
– – – – 1 2 3 4
(*1)
– – – – – 0 0 0
(*1)
• Finish beep will sound when displayed data is stored.
• (*1) : ID code range is from 3 to 4 digits when selective call
is selected.
[ ]
Set default ID code
Display Remarks
I D
Display when an item
is selected (about
0.5 seconds).
Display of the current
setting (If it is 8 or
more digits, scroll it).
Display when a code
is input (Input it with
DTMF key only).
key : Set to default
data
I D
Display when an item
is selected (about
0.5 seconds).
Display of the current
setting (Input the code
with DTMF key only).
key : Set to default
data