JVC HR-S7900U Instructions Manual page 43

AV COMPU LINK
Television
To AV COMPU
LINK II
(VCR ONLY)
To AUDIO/
VIDEO IN
FRONT AUX INPUT
VIDEO
S-VIDEO
REAR AUX INPUT
VIDEO
S-VIDEO
S-VHS ET
ON
OFF
To S-VIDEO
IN
S-video cable (supplied)
Audio/video cable (supplied)
Mini-plug cable (not supplied)
You have to select which terminal — either VIDEO (composite) or S
VIDEO (Y/C separate signals) — to use as the video input terminal on the
front panel.
Make sure to select the correct terminal; otherwise, you may fail in
recording (editing) on this VCR.
You have to select which terminal — either VIDEO (composite) or S
VIDEO (Y/C separate signals) — to use as the video input terminal on the
rear panel.
Make sure you select the correct terminal; otherwise, you may fail in
recording (editing) on this VCR.
This function allows you to record on VHS tapes with S-VHS picture
quality. Tapes recorded using this function can be played back on a VCR
equipped with the S-VHS ET function. The S-VHS indicator lights up on
the front display panel when "S-VHS ET" is set to "ON".
NOTES:
Before recording, make sure that "VIDEO CALIBRATION" is set to "ON". (
You cannot activate the S-VHS ET function...
– while recording is in progress.
– while timer-recording or Instant Timer Recording (
– while Video Calibration (
S-VHS ET does not work with S-VHS tapes.
To keep the highest quality recording and playback pictures over a long period of
time, S-VHS recording on S-VHS tapes is recommended.
Use of high grade tapes are recommended for S-VHS ET recordings.
On some tapes, picture quality will not improves even if the S-VHS ET function is
used. Check the recording quality before you start important recordings.
You can play back S-VHS ET recordings on most of S-VHS VCRs and of VHS VCR
equipped with SQPB (S-VHS QUASI PLAYBACK) function. (Notice some VCRs are
not compatible with this function.)
While playing back a tape recorded with this function on some tapes, noise may
appear. (If playback picture becomes blurred or interrupted, use a cleaning cassette.)
During special effect playback (
playback is performed frequently on a tape recorded with this function, the tape may
be damaged and picture may be deteriorated.
* The default setting is bold in the table below.
This VCR
CABLE
BOX
IN OUT
S
V
I
D
E
O
To S-VIDEO
OUT
pg. 40) is in progress.
pg. 28), noise may appear. If special effect
Refer to page 39 for setting procedures.
EN
REMOTE
IN OUT
ANTENNA IN
PAUSE/
AV
R
COMPU
-LINK
AUDIO
L
VHF/UHF
TV OUT
VIDEO
To REMOTE
PAUSE/
AV COMPULINK
To AUDIO/
VIDEO OUT
pg. 26) is in progress.
43
pg. 40)