JVC HR-S7900U Instructions Manual page 41

AUTO SP = EP TIMER
ON
OFF
DIGITAL R3
ON
OFF
VIDEO STABILIZER
ON
OFF
BLUE BACK
ON
OFF
2ND AUDIO RECORD
ON
OFF
When this function is set to "ON", the VCR automatically switches to EP
mode to allow complete recording if there is not enough tape to record the
entire program while timer-recording in SP mode.
For Example . . .
Recording a program of 140 minutes in length onto a 120-minute tape
Approximately 110 minutes
SP mode
Make sure you set this function to "ON" before the timer-recording starts.
NOTES:
If you have programed the VCR to timer-record 2 or more programs, the second
program and those thereafter may not fit on the tape with this function set to "ON". In
this case, do not use this function, but change the tape speed manually during timer
programing.
In order to ensure that the recording fits on the tape, this function may leave a slight
non-recorded portion at the end of the tape.
There may be some noise and sound disturbance where the tape speed switches from
SP to EP mode on the tape.
This function is not available during ITR (Instant Timer Recording), and will not work
properly on the following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.
When this function is set to "ON", edge correction to the luminance signal is
performed to enhance details. Normally set this function to "ON".
NOTES:
Depending on the type of tape being used, picture quality may be better with
"DIGITAL R3" set to "OFF".
If you use this VCR as the playback VCR for editing, be sure to set "DIGITAL R3" to
"OFF" before starting.
When this function is set to "ON", you can automatically correct vertical
vibrations in the picture when playing back unstable recordings made on
another VCR.
NOTES:
When you finish viewing a tape, be sure to set this function to "OFF".
Regardless of the setting, this function has no effect during recording and during
special effects playback.
The on-screen display may jitter vertically when this function is set to "ON".
To watch recordings with close-caption, set this function to "OFF".
When this function is set to "ON", the TV screen becomes all blue in the
following cases:
When receiving a channel not in use.
When stopping playback.
NOTE:
When you want to receive an unstable channel with poor signals, set this function to
"OFF".
When this function is set to "ON";
If a SAP program is received, the SAP audio is recorded on both the normal
and Hi-Fi tracks. The main audio is not recorded.
If a non-SAP program is received, the main audio is recorded on both the
Hi-Fi and normal tracks.
When this function is set to "OFF", the SAP audio cannot be recorded.
* The default setting is bold in the table below.
Approximately 30 minutes
EP mode
Refer to page 39 for setting procedures.
41
EN