Figure 2-13. Transmission Hump Trunnion Mounting - Motorola ASTRO XTL 2500 Installation Manual

Standard Configurations: Radio Mounting
2.2.1 Dash Mount with Trunnion
NOTE: This configuration is not applicable for 110W radios.
1. Select the location to mount your radio on the transmission hump (see
the dash (see
the transmission housing is not affected.
2. Using the trunnion mounting bracket as a template, mark the positions of the holes on the
mounting surface. Use the innermost four holes for a curved mounting surface such as the
transmission hump, and the four outmost holes for a flat surface such as under the dash.
3. Center punch the spots you have marked and realign the trunnion in position.
4. Secure the trunnion mounting bracket with the four self-drilling screws provided (see
Figure 2-13
5. Ensure that the plastic guides are aligned (horizontal) to the grooves of the trunnion. Slide the
radio into the grooves until it snaps into place (see
wing screws provided.
HLN6923A
Figure 2-14). When mounting the trunnion on the transmission hump take care
and Figure 2-14).
Wing Screw
Trunnion
for Wing Screw

Figure 2-13. Transmission Hump Trunnion Mounting

Figure 2-13). Secure the radio with the two
Plastic Guides
Tabs
Groove
Threaded Hole
Figure 2-13) or under
Wing Screw
October 12, 2005
2-7