Plug&Play Setup - JVC HR-J295EK Instructions Manual

10 plug&play setup
Plug&Play Setup
The TV should be set to its AV mode (if you are using both the RF cable and 21-pin SCART cable for
connection) or UHF channel 22 (if you are using only RF cable for connection).
before you start
Check that the
connection is completed
Tune the TV to your
Video Channel or to its
AV mode
Load the batteries into
the Remote Control
Refer to the Remote
Control diagram on
pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Start Plug&Play Setup
Plug the mains power cord into a mains outlet.
note Do not turn on the VCR or do not press any buttons on the VCR or
Remote Control.
what will happen? The Plug&Play screen
appears on the TV screen. Then press OK.
NOTE:
If you have connected your TV to the VCR with
only the RF cable and the on-screen display
appearing on UHF channel 22 looks distorted,
perform "
Video Channel Set
The VCR is automatically setting up the tuner
channels. This only happens the first time that you
plug the main power cord into the main outlet.
When Plug&Play is completed, the Confirmation
screen appears.
01 C03 00 ARD
" on page 14.
01 C03 00
02 C02 00
03 S40 00
04
S11 00
05 C02 00
06 - - - -
07 - - - -
08 - - - -
MOVE:
DELETE:
ACMS
ARD
ZDF
WDR3
BR3
HR3
- - - - -
- - - - -
- - - - -