System Connections; Connecting To A Satellite Receiver - JVC HR-J270 Instructions Manual

SYSTEM CONNECTIONS

Connecting To A Satellite Receiver

Connect the decoder to the satellite receiver's connector
if you have a decoder, AV1 (L-1) IN/OUT connector to
TV's connector, and AV2 (L-2) IN/DECODER connector
to the satellite receiver's connector. Then connect the
satellite receiver and TV.
Satellite receiver
Decoder
Back of recorder
IMPORTANT
When you set "L-2 SELECT" to "SAT" (
the recorder is turned off. When the recorder is in Stop mode or recording, press TV/VCR on the remote control to turn off the VCR
indicator on the front display panel.
If you turn on the recorder when the satellite receiver's power is off, nothing appears on the TV screen. In this case, turn on the
satellite receiver, or set the TV to its TV mode, or press TV/VCR button on the remote control to set the recorder to the video
mode.
Outdoor unit
Satellite cable
Mains outlet
pg. 39), it is possible to view a satellite broadcast with the TV set to its AV mode even if
NOTES:
Set "L-2 SELECT" to "L-2" (
You can use Automatic Satellite Programme Recording
function ( pg. 30) with this connection.
To view a programme via the satellite receiver, select L-2 mode
by pressing AUX (NUMBER key "0") and/or PR so that "L-2"
appears on the front display panel.
To receive a scrambled broadcast, descramble the signal with
the satellite receiver.
For details, refer to the instruction manual for the satellite
receiver and decoder.
21-pin AV input connector
Aerial
(SCART)
TV aerial cable
ANT. IN
RF OUT
EN
pg. 39).
Aerial
connector
Back of TV
33