Jenn-Air JGS8750CDS Installation Instructions Manual page 15

30" (76.2 cm) slide-in gas ranges
Hide thumbs Also See for JGS8750CDS:
Table of Contents

Advertisement

Available languages

Available languages

4. Install the green Number .0430 LP gas oven broil burner
orifice hood, turning it clockwise 4 or 5 turns. Do not
overtighten.
A. Number .0430 LP gas oven broil burner orifice hood
5. Place the oven broil burner on the oven broil burner orifice
hood. Insert the oven broil burner locator pin in the hole in the
oven back.
6. Position the oven broil burner against the roof of the oven
cavity and attach with screw.
A
B
A. Oven broil burner orifice hood
B. Oven broil burner
C. Oven broil burner locator pin
D. Oven broil burner locator hole
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips screwdriver, remove the burner base.
A
B
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
A
.0430
C
D
C
D
4. Apply masking tape to the end of a ⁹⁄₃₂" (7 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set Natural gas orifice spud aside.
A
A. Natural gas orifice spud
B. Dual burner
C. Single burner
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the gas information plate on the lower left side of
the front frame for proper sizing of LP gas orifice spuds for each
burner location.
LP Gas Orifice Spud Chart for Model JGS8850
Location
Burner Rating
Right Front
14,000 BTU
Right Rear
4,000 BTU
Left Front
13,000 BTU
Left Rear
9,100 BTU
LP Gas Orifice Spud Chart for Model JGS8750
Location
Burner Rating
Right Front
14,000 BTU
Right Rear
9,100 BTU
Left Front
9,100 BTU
Left Rear
4,000 BTU
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart." On dual
burners (on some models), replace the center and outer
spuds.
6. Replace burner base and hand tighten the screws.
7. Place LP burner choke into outer hole of dual burner (on
some models).
A. LP burner choke
B
C
Color
Number
Red
114L
Blue
64L
Center: White
Center: 55L
Outer: Orange
Outer: 97L
Clear
91L
Color
Number
Red
114L
Clear
91L
Clear
91L
Blue
64L
A
15

Advertisement

Table of Contents
loading

Table of Contents