Table of Contents
Advertisement
IF
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED
BY THE CUSTOMER. THEN YOU MAY BE LIABLE
FOR THE COST OF THE SERVICE CALL.
G
eneral troubleshooting
Water under the washer dryer
Tighten the drain pump filter.
o
o Check the drain and inlet hos
tightened.
W
asher dryer vibrates during the spin cycle
Check that the transport locking devices have been removed (see
o
installation instructions).
o Make sure that the wash
floor.
o Ensure
that all four feet are resting firmly on the floor, by pressing
down on each corner and making sure that the appliance is stable.
If it is unstable then follow the "Locating your washer dryer" and
"Levelling the appliance" sections.
Po
or spin results
Clean the drain pump (see "Cleaning the drain pump filter" section).
o
Water in the
detergent drawer
Although there will be some water residue left in the detergent
o
drawer after a wash cycle has completed. If the drawer is full of
water then you may need to clean the detergent drawer.
If a fault code reappears after following the
above advice and clearing the fault code. You
should turn the washer dryer off using the
POWER
button.
from your mains supply. Then arrange for an
engineer to attend the appliance. You should
contact
the
Department on (0118) 933 6911.
AN
ENGINEER
e and make sure that they are fully
er dryer is installed on a flat and level
Disconnect
the
Baumatic
Customer
ATTENDS
DURING
appliance
Care
THE
38
Advertisement
Table of Contents
