General Troubleshooting - Baumatic BWD1212 Instruction Manual

IMPORTANT: DO NOT ATTEMPT TO REPAIR THE APPLIANCE
YOURSELF.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then he will not complete a
repair.
This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
Please refer to the conditions of guarantee that appear on the
warranty card that you receive with the appliance.

General troubleshooting

Water under the washer dryer
o Tighten the drain pump filter.
o Check the drain and inlet hose and make sure that they are fully
tightened.
Washer dryer vibrates during the spin cycle
o Check that the transit bolts have been removed (see installation
instructions).
o Make sure that the washer dryer is installed on a flat and level
floor.
o Ensure that all four feet are resting firmly on the floor, by pressing
down on each corner and making sure that the appliance is stable.
If a fault code reappears after following the
advice given above, you should turn the wash
program selection knob to the off position.
Disconnect the appliance from your mains
supply. Then arrange for an engineer to
attend the appliance. You should contact the
Baumatic Service Department on (0118) 933
6911.
25