Control Two Jvc Vcrs - JVC HR-DD740U Instructions Manual

54
EN
NUMBER "1"
1
¶
POWER
1 2 3
4 5 6
7 8 9
0
3 ¡
7 8
4 ¢
SPECIAL FEATURES (cont.)

Control Two JVC VCRs

The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to B code
control signals. The remote control is preset to send A code
signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR to respond to B code
signals.
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET REMOTE CONTROL
CODE
2
While holding down A/B on the remote control, press
the NUMBER key "2" and then press STOP.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press POWER on the remote.
The VCR will now respond only to B-code commands.
To set the VCR to respond to A code signals again, repeat the
above procedures setting the A/B CODE switch to A, instead of
B, in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B.