Installing Your New Recorder; Basic Connections - JVC HR-A630EK Instructions Manual

4

Basic Connections

Aerial terminal
It's essential that your video recorder be properly connected.
Follow these steps carefully. THESE STEPS MUST BE COM-
PLETED BEFORE ANY VIDEO OPERATION CAN BE PER-
FORMED.
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "Specifications" (
SITUATE RECORDER
2
Place the recorder on a stable, horizontal surface.
CONNECT RECORDER TO
TV
3
The connection method you use depends on the type of
TV you have.
RF CONNECTION
To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV aerial cable from the TV.
b– Connect the TV aerial cable to the ANT. IN jack
on the rear panel of the recorder.
c– Connect the provided RF cable between the RF
OUT jack on the rear panel of the recorder and the
TV's aerial terminal.
Before operating the recorder, make sure the TV's preset
is set to the VIDEO preset.
AV CONNECTION
To Connect To A TV With AV Input Terminals . . .
a– Connect the aerial, recorder and TV as per "RF
CONNECTION".
b– Connect an optional SCART cable between the
AV1 IN/OUT socket on the rear panel of the
recorder and the TV's 21-pin SCART connector.
c– Set the RF OUT switch to OFF.
Before operating the recorder, make sure the TV is set to
the VIDEO (or AV) mode.

INSTALLING YOUR NEW RECORDER

Back of TV
21-pin SCART connector
pg. 43).
RF Cable (provided)
21-pin SCART Cable
Mains outlet
CONNECT RECORDER TO
MAINS
4
Plug the end of the mains power cord into a mains
outlet.
Mains Power
Cord
L
R
AUDIO OUT
RF OUT
ON–TEST–OF