Help And Tips - Polaroid TLU-44243B User Manual

10

Help and tips

Failure
The television does not
function
Poor picture quality
Shadow and reflection in the
picture.
No picture
No color.
No or defective teletext
No sound
Remote control does not
work
Picture is not readable after
turning on the TV
If your television does not work properly even though you tried the above mentioned
solutions, try turning it on and off again. If you cannot start your television even though you
have applied all noted methods, refer to the dealer or authorised service from where you
purchased the product. Never attempt to repair a faulty device yourself.
Possible cause
Is the power cord connected to
the mains supply?
Is the main power On/Off button
on?
Is the antenna cable attached?
If you are using a satellite antenna,
is it well adjusted?
Antenna may be affected by two
connected external devices.
It may need fine tuning.
Picture settings are not correct.
Channel setting
Antenna
Is there any damage on the
antenna cable?
Are you sure you pressed the
correct button on your remote
control?
Color intensity level is at the
lowest setting.
Broadcast system setting (if
setting choice is available)
Problem in channel broadcasting.
Television channel (no teletext) or
antenna system.
Very weak signal
Temporary sound mute may be
on
Is the sound turned down?
Are the batteries correctly placed?
Are batteries exhausted?
Is there any obstacle between the
remote control and television?
Child lock is active.
28 I
GB
Solution
Check the power cord.
Check if the On/Off button is
on.
Check the antenna cable.
Have the antenna adjusted.
Try disconnecting one of the
devices.
Perform fine tuning.
Adjust Brightness, Contrast
and Color.
Perform automatic, manual
channel setting or fine tuning.
Check antenna cable and
system
Check the antenna cable.
Press PR+ or PR- button to
turn on the TV.
Lighten the color.
Select the broadcast system.
Test with another channel.
Test another channel for fine
tuning and shadowy pictures
Check the antenna system.
Try pressing the mute button
Turn on the volume with Vol +
button.
Place the batteries correctly.
Replace the batteries with new
ones.
If yes, remove it.
Disable the child lock.