Lennox MPD35ST-NM-B Installation Instructions Manual page 30

INSTALLATION STEPS:
READ WARNINGS ON Page 29 BEFORE PROCEEDING
. Remove the front glass enclosure pan el (see Glass Enclosure Panel
Removal Instructions, Page 31).
2. Remove the following from firebox; log set, bag of embers and bag
of vermiculite. Handle logs carefully to prevent breakage.
3. Ensure the Grate is properly installed in the firebox with the 4 legs
of the grate fitting into the 4 dimples on the firebox floor.
4. Install Vermiculite - Place some vermiculite on the firebox floor around
the grate (the entire bag of vermiculite will NOT be used). See Figure 61
on Page 32. DO NOT PLACE ANY VERMICULITE ON THE BURNER.
5. Placement of Glowing Embers -
Separate the Embers (rockwool) into pieces about the size of a quarter
(see Figure 52). Keep the pieces fluffed up, not matted. Distribute
these pieces over the surface of the burner, as shown in Figure 53.
Do not use more than is necessary. Ensure that the main burner ports
remain uncovered by the ember material.
Note: This appliance is provided with enough Glowing Embers for
several applications, do not use all that is in a new bag at one time. For
best glowing effect, replace the ember material annually. Replacement
Glowing Embers are available (order Catalog Number 88L53).
Place Embers on burner as shown.
DO NOT PLACE EMBERS OVER
Figure 53
GAS PORTS / AREAS CIRCLED
6. Place Log (A) on the grate as shown in Figure 54
A
Position Groove At The Bottom Of
Log (A) Over The Log Support Here
Figure 54
30
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Position The Groove At The Bottom Of
Log (A) Over The Grate And Slide It
Forward Against The Grate Here
(Valve Access Side)
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
7. Place Log (B) as shown in Figure 55.
Position Log (B) Against The Back Of
The Grate Here
B
Position Groove at The Bottom Of Log (B) Over The Grate
Here And Slide It Against The Back Of The Grate
(Valve Access Side)
Figure 55
8. Place Log (C) as shown in Figure 56.
Log (C) Lays Over Logs (A) and (B)
B
C
Position The Groove in The Back of Log (C)
Against The Grate
Figure 56
9. Place Log (D) as shown in Figure 57.
(Valve Access Side)
Figure 57
A
(Valve Access Side)
Position And Slide Log (D) Against The
Back Of The Grate
A
D
Place Log (D) Over The
Flat Spot On Log (A) Here