Video Channel Set - JVC FST-GTK2I HR-J240E Instructions Manual

Video
Channel Set
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
The video recorder is designed to send picture and sound signals
via the connected RF cable to your TV on UHF channel 36.
After you have turned on the recorder, set your TV to UHF
channel 36, fine-tune as necessary, and check if picture and
sound being received from the recorder come out clearly or not:
If clear enough
If not
Before starting, make sure of the following:
The recorder's power should be off.
No cassette should be inserted in the recorder.
The connected TV's power should be on.
2 3
1
q 5/8 6
2
3
4
TEST SIGNAL
To view picture signals from the video recorder, set
your TV to the Video Channel.
you don't have to perform the following
steps.
UHF channel 36 or neighbouring channels
may be occupied by local stations. Perform
the following steps to change the Video
Channel to another channel between 32 – 40.
SET TV CHANNEL
Set your TV to a channel between 32 and 40 that you
want to use as the Video Channel on the TV.
BRING TEST SIGNAL ON
SCREEN
Hold down the recorder's STOP/EJECT button for more
than 5 seconds.
"– OUT" appears on the display panel.
TUNE YOUR RECORDER
Turn the RF output channel adjustment screw on the
rear panel of the recorder by using a screwdriver until
the two vertical bars become as clear as they can be.
EXIT VIDEO CHANNEL SET
MODE
Press the recorder's STOP/EJECT button again to finish
the setting.
The channel on which the screen to
the left appear clearly in step 3 is
your Video Channel.
5
EN