Table of Contents
Advertisement
You can use your video recorder as the source player or the
recording deck.
A
Make connections
Connect the player's AUDIO/VIDEO OUT connector to the
recorder's AUDIO/VIDEO IN connector.
Use the L connector for monaural connection.
B
Set recording deck's input mode
Set to AUX. With this video recorder, press number key "0" and/or
PR +/– to select depending on the connector being used — "L-1"
for the rear panel VIDEO/AUDIO input connectors, or "F-1" for
the front panel VIDEO/AUDIO input connectors.
C
Select "EDIT" for picture control set mode
Follow the "Picture Control" section on page 15, then select
"EDIT."
D
Start source player
Engage its Play mode.
E
Set recording deck
Engage its Record mode.
NOTES:
To edit, both the player and the recorder must be of the same
colour system. Select the appropriate colour system (
When you use this recorder as the player for editing, be sure to
set "O.S.D." to "OFF" before starting (
All necessary cables can be obtained from your dealer.
NTSC tapes being played back in the "NTSC]PAL" mode
(
16) cannot be dubbed to another recorder.
When you dub an NTSC tape using your recorder as the
playback deck, select "NTSC 3.58" (or "NTSC 4.43") for "NTSC"
setting (
16).
When you select "EDIT" to dub tapes, be sure to select "AUTO"
(or "NORM" when the B.E.S.T. function is set to "OFF") after
you finish dubbing the tapes (
If you are using another recorder with S-Video and Audio input/
output connectors, you can connect those connectors to this
recorder's S-VIDEO IN/S VIDEO OUT and AUDIO IN/OUT
connectors.
When Using Your Video Recorder As The Source Player ...
... connect its rear panel S VIDEO OUT and AUDIO OUT
connectors to the recording deck's S-Video and Audio input
connectors.
When Using Your Video Recorder As The Recording Deck ...
... connect its front panel S-VIDEO and AUDIO input
connectors to the source player's S-Video and Audio output
connectors. Then, set the recorder's input mode to "S-1".
16).
16).
15).
System Connections
Connecting/Using a Stereo System
These instructions enable you to connect your video recorder to
your Hi-Fi stereo system (if you have one) and listen to the
soundtrack through the stereo.
FM Tuner
CD Player
Stereo Amplifier
Speaker
Television
Mains
outlet
Make Connections
Connect the AUDIO OUT L and R connectors on your video
recorder to the AUX IN or TAPE MONITOR terminals on your
stereo system's receiver or amplifier.
NOTES:
When connecting your recorder's audio output connectors to a
stereo amplifier, make sure you connect L and R correctly.
If stereo or bilingual TV broadcasts are receivable in your area,
this recorder can record them independently of the TV set and
play them back through the connected stereo system.
When listening to sound through the connected stereo system,
turn the TV's volume down completely.
CAUTIONS
This recorder has a dynamic range of more than 80 dB with
regards to its Hi-Fi audio capability. It is recommended that you
check the maximum level if you are going to listen to the Hi-Fi
audio signals through a stereo amplifier. A sudden surge in the
input level to the speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do
not place the speakers adjacent to the TV set as this can
adversely affect the video playback picture.
— 21 —
I
AUX IN or TAPE MONITOR
Audio Cable
(not provided)
Speaker
AUDIO OUT
(MONO)
Rear View
Advertisement
Table of Contents
